Pacific Seacraft Dana 24

Sails and Rigging

Cutter-rigged with a 110% jib on a furler (2018) halyard is led aft; a reefable inner staysail with piston hanks; and a mainsail with 2 reefs and Lazy Jacks, mounted with a Tides Marine track and slide system.

Harken Ball Bearing Mainsheet Traveler

Mast Climber

Steadying Sail for use while at anchor

 

Engine and Propulsion System

Auxiliary power is a Yanmar 2GM20F 18 hp diesel engine with fresh-water cooling. Current engine-hours reading is 1,167.4.

Single Lever Throttle / Shift Control

18 Gallon Fuel Tank

Panel with Tachometer

Racor Fuel / Water Separator

Raw Water Strainer

Water Lift Muffler System

Engine access hatch in cockpit

Navigation and Electronics

Principal navigational aid is a Raynav 300 GPS with receiver mounted on the stern rail, wired for laptop-based navigation software. For self-steering the boat is equipped with a Raymarine ST2000+ tiller pilot with Remote Control.

ICOM 502 VHF Radio with Remote Mic

Ritchie BN202 Bulkhead mounted Compass

Electrical

Factory wired for 110V shore power, with a 50' cord and adapter. Five duplex outlets below. Main power (12 V), is charged (by the standard engine alternator) and from a 110-12 V shorepower converter, or from a 60-W solar panel mounted on the seahood.

55 Amp Alternator

Lightning Ground

Masthead Anchor Light

 

Mechanical and Accessories

Laminated Wood Tiller

This boat has an Airhead composting toilet (original fixed toilet plumbing, including a pump-out facility, is still in place).  

An Espar diesel-fired  furnace provides forced-air heating down below.

Bronze Thru Hull Fittings

Solid Teak Drop Boards

Flag Staff on Sternrail

Canvas

A removable bimini protects most of the cockpit area.

Two Folding Cockpit Cushion Chairs

Boom Cover

 

Hull and Deck

This boat has a painted stainless steel bowsprit copied from the original fir sprit.

Sliding Hatch and Sea Hood

Cockpit Seat Lockers

Aluminum toe rail with two Harken snatch blocks

Deck Hardware includes two Harken #8 winches mounted on the aft part of the cabin top. plus 2 winch handles

Two three sheave turning block organizers

Two Spinlock triple stoppers (Port and Starboard)

Stern and Midship cleats 8" chrome

Stainless Steel Handrails on the Cabin Top

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

Ventilation

Forward Hatch (Bomar) with screen

Four 7" x 12" Chrome Opening Ports, 

Four 4" x 7" Chrome Opening Ports

Weather shields on four ports

Safety

Transom Boarding Ladder with Teak Treads

27" Stanchions supporting Double Lifelines and Boarding Gate

Stainless Steel Double Bow and Stern Rails 

12V Bilge Pump and Manual Bilge Pump in Cockpit (25 GPM)

Lifering on Sternrail

Two Life Jackets with Harnesses

Ground Tackle

Delta 22lb primary Anchor with 250' Rode, including 30' of Chain

Danforth second Anchor with approximately 100' of rode

Two Anchor Rollers

Sea Anchor

Bow and Stern Chain Lockers

Two 10" Chrome Bow Mooring Cleats with Hawse Pipes

Galley

Force 10 Two Burner Gimballed Propane Stove with Oven and Broiler

Large Icebox with pump out drain to sink

Deep Stainless Steel Sink with Fresh Water Foot Pump

Food and Dish Storage Lockers and Drawers

10lb Propane Tank in dedicated locker with hatch, plus extra tank

 

Accomodations

Vee Berth dimensions : 6' long and 6' 9" wide

Teak and Holly Cabin Sole